Page 1 of 1
ROI editing in Advanced version
Posted: Wed Oct 07, 2020 3:13 pm
by jose_carlos_pichardo
When I acquire a new reference capture after shifts, I will sometimes need to edit the ROI. I am finding it difficult to see the ROI because it shows up in PHOTO mode, versus the previous white opaque ROI. Is there a way to switch back and forth between the photo ROI and the white ROI?
Re: ROI editing in Advanced version
Posted: Wed Oct 07, 2020 4:22 pm
by marko_laaksomaa
Hello Jose
I think you need to select SURFACE DISPLAY from the side bar and select an option you want to use. AlignRT quick start guide 6.11.1.
Regards Marko
Re: ROI editing in Advanced version
Posted: Wed Oct 07, 2020 4:43 pm
by marko_laaksomaa
Or 7.17.3. Select or deselect 3D photo in the surface display, if you mean that. That is unknown feature to me.
Re: ROI editing in Advanced version
Posted: Thu Oct 08, 2020 8:18 am
by marko_laaksomaa
Back at work. We also have that 3D photo active. We have not much paid attention to that. If you think that it is easier to edit ROI without 3DPHOTO: after you have acquired reference capture, from treatment side bar 1) select surface display and 2) deselect 3D photo. Then 3) Edit ROI. Seems to work on the fly on AlignRT treatment view also. I have to add here that Advance quick start quide book is great. It is very informative, practical and clear. Likewise is the version 6.2 as well. ALL the AlignRT users here in Tampere thinks that 6.2 is SIGNIFICANTLY easier and more pleasant to use than the previous one.